TP-1 Drill Powered Hydrostatic Test Pump

$450.00

Pressure Test Anywhere up to 250 psi with a cordless drill. The TP-1 Hydrostatic Test Pump is the best drill powered hydrostatic test pump on the market. At only 5lbs and self-priming up to 6' you will never even think about carrying a gas powered hydrostatic test pump or electric hydrostatic test pump with you again.

  • Powered by a cordless Drill
  • Weights approximately 5lbs
  • Brass and stainless steel construction
  • Capable of pressures up to 250psi
  • self priming up to 6'
SKU: TP-1 Category:

Description

Why a Drill Powered Hydrostatic Test Pump

What would you do if you didn’t have to carry a 150 lb gasoline powered hydrostatic test pump onto the job site? How much more efficient would your crews be if you could pressure test your piping system up to 250 psi with only 10 lbs of gear?

What would you do if you didn’t have to wait for the job site to have electricity, or rent a generator so you could use your electric hydrostatic test pump? How much more efficient would your crews be if you could pressure test your piping system as soon as you finished installing it?

The TP-1 Hydrostatic Test Pump by Aimpoint Associates has turned the hydrostatic test pump market upside down. The TP-1 hydrostatic test pump solves all of your problems and is powered only by a typical cordless drill. The need for electric power on the job site is gone! The TP-1 weighs only 5lbs, a full 145lbs less than a typical gas powered pump. This pump will not only save you money up front but will continue to pay for itself over and over again with continued labor savings, and your crews will thank you.

See our drill powered Hydrostatic Test Pump in Action

This hydrostatic test was conducted on a Fire Sprinkler System using the prototype of the TP-1 Hydrostatic Test Pump. The sprinkler system was installed in a two story office building. The system capacity is approximately 600 gallons. The system was filled up to normal city pressure of approximately 120 psi.

TP-1 Drill Powered Hydrostatic Test Pump Description

The TP-1 is a cordless drill powered pump used to pressurize closed piping systems for leak testing. With the capability of using a cordless drill to power the pump you no longer need to have a power source to plug into or an expensive gasoline engine. The pump weights approximately five pounds making it much more portable than electric or gasoline powered pumps. The TP-1 is capable of pressuring a piping system up to a maximum of 250psi and is self-priming up to six feet.

  • – Weighs under 5 pounds
  • – Hand held
  • – Self Priming up to 6 feet
  • – Can test when there is no available electric power source
  • – Brass and Stainless steel construction

Hydrostatic Test Pump Brochure